GET 5% Discount on all orders using the code 5OFF2021 at the checkout Monday to Friday from 10am to 5pm

ECO 1 Stage Lighting Kit Assembly

Stage Lighting Kits: ECO 1 (SLK/ECO1)

Firstly, thanks for buying one of our stage lighting kits, we really appreciate it and if we can be of any help please don’t hesitate to contact us.

We’ve tried to make these instructions as clear and concise as possible, we know not everyone is technically minded but by following the description below you should be creating beautiful lighting effects in no time!

Important Information

It is important that the power is only connected once the kit is fully assembled. Lights can get hot once powered up, please use caution. If you need assistance at any time please contact us for technical support.


This stage lighting kit contains:

4x Par 56 Lights fitted with IEC plugs, a lamp and colour frame

1x T-Bar Stand

1x 4 Channel IEC DMX Dimmer

1x 6 Channel DMX Controller

1x 20M 2 Pin DMX Cable

1x 10M Mains Extension Cable

1x Dimmer Bracket

1x Gel Selection



Remove all packaging and check you have the parts listed above.

  1. Assemble the T-Bar Stand as per the supplied paper instructions.
  2. Using the nut and bolt sets in the T-Bar undo each one in turn and hold the hole on the yoke of the Par 56 up to the bolt, return the nut and tighten, this can be above or below the bar, the choice is yours. Do this for each of the 4 lights.
  3. You can tighten the lights to stop them drooping using the knob on the side.
  4. Fix the dimmer bracket onto the back of the dimmer using the centre hole at the top of the dimmer unit.
  5. Open the dimmer bracket and clamp it around the stand pole so the dimmer faces forward and is vertical.
  6. Tighten the dimmer bracket.
  7. Plug each IEC connector on the lights into one of the sockets on the dimmer, do this in a line using one row only.
  8. Insert the gel into the colour frames and slide them into the front of the lights (they may be tight).
  9. Take the 20M 3 Pin DMX cable and plug it into the back of the small 6 channel controller (it can only go one way).
  10. Plug the opposite end of the DMX cable into the DMX In port on the bottom of the Dimmer.
  11. Plug the power supply into the back of the 6 Channel controller.
  12. Plug the 10M Mains extension cable into the bottom of the Dimmer.
  13. Plug in both plugs and turn the power on.
  14. Switch both the Dimmer and Controller on using the power switches.

And you’re done!

If you have any questions please don’t hesitate to contact us .

WordPress Theme built by Shufflehound. © 2021 All Rights Reserved.